8.1 基本的集成ISIS配置 图8-1 ISIS基本配置网络拓扑 1.R1配置 [R1]isis 1 [R1]interface GigabitEthernet 0/0/0 [R1-GigabitEthernet0/0/0]isis enable 1 [R1]interface LoopBack 0 [R1-LoopBa...

图8-2  多区域集成ISIS配置网络拓扑 1.R1配置ISIS [R1]ISIS 1 [R1-isis-1]network-entity 49.0001.0000.0000.1111.00 [R1]interface GigabitEthernet 0/0/1 [R1-GigabitEthernet0/0/1]isis ena...

图8-3  ISIS认证配置网络拓扑 1.接口认证 1）配置R1与R2的level-1接口认证 [R1]interface GigabitEthernet 0/0/1 [R1-GigabitEthernet0/0/1]isis authentication-mode simple dsrw.com level-1...

图8-4 ISIS路由泄露网络拓扑 1.R2使用ACL匹配要泄露的路由，匹配到level-1默认L1会引入L2中，L2不会引入到L1中 [R2]acl 2000 [R2-acl-basic-2000]rule permit source 6.6.6.6 0 [R2]isis 1 [R2-...

图8-5 ISIS路由汇总网络拓扑 1.L1区域路由通告给L2时进行汇总 1）R2将49.0001的路由1.1.1.1/32同步到L2区域是汇总为1.1.1.1/24 <R3>display ip routing-table protocol isis 1.1.1.1/32 ISIS...

图8-6 ISIS手动产生默认路由网络拓扑 1.查看R1、R6默认路由（由Level-1-2产生缺省路由） <R1>display ip routing-table protocol isis 0.0.0.0/0 ISIS-L1 15 10 D 12.1.1.2 GigabitEthernet0...

图8-7 ISIS协议重分布网络拓扑 1.R6、R7配置OSPF [R6]ospf 1 router-id 6.6.6.6 [R6-ospf-1]area 0 [R6-ospf-1-area-0.0.0.0]network 67.1.1.0 0.255.255.255 [R7]ospf 1 router-id 7.7.7.7 [R7...

图8-8 ISIS支持IPV6网络拓扑 1.R1配置IPV6地址 [R1]ipv6 [R1]interface GigabitEthernet 0/0/0 [R1-GigabitEthernet0/0/0]ipv6 enable [R1-GigabitEthernet0/0/0]ipv6 address 2001::1/64 [R1]i...

9.1 策略路由 图9-1策略路由网络拓扑 1.R1配置OSPF [R1]ospf 1 router-id 1.1.1.1 [R1-ospf-1]area 0 [R1-ospf-1-area-0.0.0.0]network 1.1.1.1 0.0.0.0 [R1-ospf-1-area-0.0.0.0]network 12.1....

图9-2路由过滤网络拓扑 1.R1配置ISIS [R1]isis 1 [R1-isis-1]network-entity 49.0001.0000.0000.1111.00 [R1]interface GigabitEthernet 0/0/0 [R1-GigabitEthernet0/0/0]isis enable 1 [R1]int...