图4-6  OSPF路由引入网络拓扑 1.R3新生成直连路由，宣告进OSPF [R3]interface LoopBack 0 [R3-LoopBack0]ip address 3.1.2.1 255.255.255.0 sub [R3-LoopBack0]ip address 3.1.3.1 255.255.255...

1.查看R1的OSPF路由信息的COST值 <R1>display ip routing-table protocol ospf Destination/Mask Proto Pre Cost Flags NextHop Interface 2.2.2.2/32 OSPF 10 1 D 12.1.1.2 GigabitEthernet...

1.在R1查看R2环回接口的OSPF的COST值 <R1>display ip routing-table protocol ospf Destination/Mask Proto Pre Cost Flags NextHop Interface 2.2.2.2/32 OSPF 10 1 D 12.1.1.2 GigabitEthe...

1.R3查看OSPF路由信息 [R3]display ip routing-table protocol ospf Destination/Mask Proto Pre Cost Flags NextHop Interface 0.0.0.0/0 O_ASE 150 1 D 34.1.1.4 GigabitEthernet0/0/0 1.1.1....

图18-1 PPPoE配置网络拓扑 1.PPPOE server 地址池配置 [R2]interface LoopBack 0 [R2-LoopBack0]ip address 2.2.2.2 32 [R2-LoopBack0]quit //模拟公网 [R2]ip pool pppoe //创建地址池用于分配...

图4-5  OSPF路由引入网络拓扑 1.R4创建新的直连路由，OSPF引入外部路由 [R4]interface LoopBack 1 [R4-LoopBack1]ip address 44.1.1.1 32 [R4-LoopBack1]quit [R4]interface LoopBack 2 [R4-Lo...

图3-2 RIP手动路由汇总配置网络拓扑 1.R1基本配置 [R1]interface LoopBack 0 [R1-LoopBack0]ip address 1.1.1.1 24 [R1-LoopBack0]quit [R1-LoopBack0]ip address 1.1.2.1 24 sub [R1-LoopBack0...

1.修改R1的G0/0/0口为Silent-interface类型（静默接口），查看OSPF信息（不收发任何OSPF报文） [R1]ospf 1 [R1-ospf-1]silent-interface GigabitEthernet 0/0/0 [R1]display ip routing-table p...

1.创建VLAN [sw1]vlan batch 11 to 30 [sw2]vlan batch 11 to 30 [sw3]vlan batch 11 to 30 2.配置trunk [sw1]interface GigabitEthernet 0/0/1 [sw1-GigabitEthernet0/0/1]port link-type trun...

1.R1配置 [R1]interface Serial 0/0/0 [R1-Serial0/0/0]ip address 12.1.1.1 30 [R1-Serial0/0/0]link-protocol fr [R1-Serial0/0/0]fr interface-type dte [R1-Serial0/0/0]fr inarp 2.R2配置 ...